Menu
Cart 0

How to reset E-mod to correct model and serial number

Posted by Bob Wert on

How to reset E-mod to correct model and serial number:

(Solution for Errors 1:10 & 1:12)

  1. Power up while pressing UP and ENTER (service mode)
  2. Choose SERVICE UTILITIES
  3. Choose EEROM SETUP
  4. Enter serial #, model # and font type
  5. Switch power off and back on
  6. Perform paper advance calibration


Share this post



← Older Post Newer Post →


Leave a comment

Please note, comments must be approved before they are published.

x