Designjet 500 Service Station Installation Problem
Posted by Bob Wert on
I am trying to install the service station, and for whatever reason, the screw holes aren't lining up. Is there supposed to be a space in between the part and the machine?
Putting the service station back into the plotter can be a little tricky the first time.
Hold the SS under the SS bracket and then go straight up and then in toward the frame. There is a lip on the front edge of the SS that has to ride on top of a plastic ledge on the bracket. When it is in correctly, it will be against the frame of the plotter and no room between the SS and the screw holes (when held all the way up).
Hope this helps.
Share this post
0 comment