Tech Help — Designjet Z3200

"Printhead replacement incomplete" after "preparing print system" on a T610, T620, T770, T790, T1100, T1120, T1200, T1300, T2300, Z2100, Z3100, Z3200, Z5200 or Z5400? This is usually not enough ink reaching the printheads: a non-HP cartridge, a cartridge below 40% full, or air in the ink tubes. Install HP cartridges above 40% full and purge each ink line with the priming tool. If the tube system is compromised, the seal upgrade kit is the easier and cheaper fix. Parts you may need: Universal Designjet ink tube priming tool | Printhead seal upgrade kit for T and Z models | HP... Read more →

This problem occurs in the following HP Designjet models: T610, T620, T770, T790, T1100, T1120, T1200, T1300, T2300, Z2100, Z3100, Z3200, Z5200, Z5400.  If your printer is rejecting HP 70 printheads or HP 72 printheads, or if the printheads seem generally unreliable, there's a good chance there's nothing wrong with the printheads themselves. Often the contacts on the trailing cable corrode, and fail to send a consistent signal to and from the printheads. If you're on your second or third replacement printhead, and about ready to put some creatively-placed holes in the printer, power the machine off, and check the... Read more →

Error 02.1:10 on a Designjet T1100 or T610 This is a printhead voltage fault on the carriage PCA. First try a different printhead in case one is pulling the carriage PCA down. If the error stays, replace the carriage (it comes with the PCA installed), and consider replacing the trailing cable at the same time. Parts you may need: T610, T1100 carriage with PCA Q6687-67009 | 44" trailing cable Q6659-60177 | 24" trailing cable Q5669-60681 "I am asking for your valuable help. When I was testing carriage assbly on mode access to plotter HP T 1100 it did not pass.... Read more →